XT Series Side Accessible Picnic Table - Using Lumber

View Description

Model: XT

Configure Product

Frame Finish

Select the finish you want on the frames.
Material Options

MATERIAL & LENGTH CHOICES

Select the Material and Length you want for this product.
($340.00)
($372.00)
($526.00)
($550.00)
($334.00)
($365.00)
($516.00)
($539.00)
Material Options

Product Description

Series Overview

Model XT Side Accessible Picnic Tables are designed and constructed specifically for heavy use areas where unusually difficult service may be required.  A section of seating is removed from the side(s) for ADA COMPLIANT wheelchair accessibility right in the middle of activities.  Table configurations meet or exceed current ADA guidelines for wheelchair access to picnic tables.

Specifications:

Model XT Side Accessible Picnic Tables feature our non-tip, non-trip, walk through design.  The table won’t tip even if all persons sit on one side.  Easy walk through access.  “Skid” design permits movement without damage to turf. 

Model XT 6 and 8 ft. Side Access Picnic Tables provide one side opening with 2 one-person seats located on either side of wheelchair.  These tables can comfortably seat 6-7 people. 

Model XT 10 and 12 ft. Side Access Picnic Tables provide two locations for wheelchairs which are diagonally opposite each other.  Current ADA guidelines require two wheelchair spaces on these larger tables.  Each side includes a shorter one-person seat plus a longer seat to accommodate 3-4 people.  These tables can comfortably seat 10-12 people.

Model UT Side Accessible Tables offer 30” nom. table height (to top of table); 18” nom. seat height.  Diagonal braces are used to support and reinforce the table structure.  Brace positioning allows wheelchair spaces to meet current ADA clearance guidelines of 30" wide, 27" under table (ground to bottom of table top), and 24" total knee and toe clearances (19" knee + 5" toe).

FRAME: All welded 2-3/8" OD steel pipe end frames (2.375" OD, 11 ga. wall, 2" ID nom. pipe specifications). Top/seat mounting angles are 2" x 2" x 3/16" steel angles.  Frames supported by diagonal braces of 1-5/16" OD steel pipe attached to steel center channel.  All 3/8" dia. galvanized carriage bolt fasteners.  Warranted for life.

FINISH: Standard finish: hot dip galvanized after fabrication.  Or choose a powder coat finish (in place of galvanized finish) in your color choice.

LENGTH: 6, 8, 10 or 12 ft lengths.

TOP/SEAT MATERIALS: 2” x 10” (nom.) untreated or pressure treated #1 southern yellow pine. See Material Options.

OPTIONAL: To anchor table to a concrete surface, use Model ANC6-4 Anchor Kit (Concrete Screws) and Model ANG-3 Anchor Kit (Anchor Straps).

 

Website design and development by Spindustry Digital, Des Moines, Iowa