Model FS-30/18/PA accessible campfire ring includes the simple single level cooking grate.  The 290 sq. inch grate can be laid over the fire, or tipped over and out of the fire ring, but it remains permanently hinged to the ring.

This taller fire ring, available in 18" or 24" (nom.) tall designs, brings the cooking surface to a convenient height for use from a wheelchair.

The fire ring is rolled using 3/16" thick steel, with 1" formed flange for strength and safety.  The welded cooking grate uses a 3/4" dia. handle bar, 5/8" dia. perimeter bar and 1/2" dia. grate bars, and includes handle grips of 1/8" x 1/2" coiled steel.  All grate bars are welded on both sides.  Finished with high temp non-toxic black enamel paint.  Pin anchors provide a fixed location and must be set in concrete.

The fire ring is filled with aggregate (not included) to about 9" above the ground to provide the elevated fire surface needed for wheelchair access.  This fill also insulates the ground to reduce the chance of root fires in heavily wooded areas.  Drain/draft holes are provided around the perimeter of the campfire ring.

OPTIONAL: Bolt on utility shelf Model S5

OPTIONAL: Heat Shield (add /H to end of model number). An optional welded-on Heat Shield is available on some Pilot Rock campfire rings.  This welded-on shield can be added to new Pilot Rock campfire rings to give protection from hot surfaces around the outside of the ring.  The 10 ga. x 8" high Shield provides a 7/8" air gap around the area of these tall fire rings exposed to heat (the lower portion of these fire rings is filled with aggregate).  NOTE: Not available on campfire rings less than 11 inches tall.

 California's Proposition 65.